MIPRO act707d(2ce150)b - Manual (Page 13)

2 2 23
BELT PACK TRANSMITTER BELT PACK TRANSMITTER
4. FUNCTIONS OF LCD DISPLAY
(Fig.4)
(Fig.3)
5. BATTERY INSTALLATION
1. Pushing down both snap locks on the sides of battery cover to open battery
cover. Take out the batteries. Fig. 3).
2. Inserta two 1.5(AA) batteries into the batterycompartmentaccording to the
correct polarity as shown in Fig.3). Then push up to close the battery
compartment as shown inFig. 4).
PS: When the microphone i s n o t in use:
Make sure the p ower ofthe microphone is off. If the microphone will not
be used for some time,pleaseremove the batteries from the battery
compartment to avoid battery leakage and result indamaged b attery
springs andcircuit. If a rechargeable battery was used, take it out and
recharge it.
E R R
GROUP CHANNEL BAT
ERR no01 EEPROM is not being programmed or internal data error.
ERR no02 For testing only.
ERR no03 The frequency you are about to program into the system exceeds
microphone's upper limit. (At this time, microphone is still
operatable and the frequency remains unchanged. To clear the
"ERR" message in LCD display, simply turn off the power and
switch back on.)
ERR no04 The frequency you are about to program into the system is below
microphone's frequency lower limit. (At this time, microphone is still
operatable and the frequency remains unchanged. To clear the
"ERR" message in LCD display, simply turn off the power and
switch back on.)
→
→
→
→
2. "Group" & "Channel " : When both items are shown, they indicate that the user
is currently using the pre-programmed frequency in the receiver.
3. "Channel" Only : If "Channel" is the only item shown in the display, it indicates
the user is using the personalized frequency.
4. Battery Status:
Battery Status: When the battery has less than 10% power remaining, batteries
must be replaced. If undervoltage continues, LCD will show "PoFF" and shut down
the system to avoid battery being over-discharged.
100% 80% 40% 10% 0%
5. Switch Off:
When switch the power knob to "Off" position, LCD will show "PoFF" first.
Then, the system is completely shut down and no further message will be
displayed.
1. ERR Message: When "ERR" appears, it means "Operation Error". Please refer
to the following codes to diagnose which error you are experiencing.