Applied Motion 3540i - Manual (Page 4)

-17- -4-
Getting Started
To use your 3540i motor control, you will need the following:
✔ a power supply (see page 5 for help in choosing one).
✔ a compatible step motor (see page 17 fopr recommended motors)
✔ a small flat blade screwdriver for tightening the connectors - an Applied Motion
Products screwdriver suitable for this purpose is included with your drive.
✔ a personal computer running Windows 3.1, 95 or NT with a 9 pin serial
port (486 or better with 8 MB ram recommended)
✔ the Si Programmer™ software that came with your 3540i
✔ the programming cable that came with your 3540i
✔ Si Programmer™ manual
The sketch below shows where to find the important connection and adjustment
points. Please examine it now.
Mechanical Outline - 3540i
Recommended Motors
2.45"
4.70
0.150"
3.00
0.25
5.00
0.15
4.70
1.50
0.25
.875
4x Ø.170
2x SLOT
.170 WIDE
FULL R
power connector
• DC power supply
• motor mounting hole (1 of 6)
pc/mmi
connector
power
LED
connector
• input 1,2,3,4
• jog cw
• jog ccw
• cw limit
• ccw limit
connector
• output1,2,3
Always use the blue & white Applied
Motion screwdriver with these
connectors. Larger screwdrivers may
remove the plastic dimples that
prevent the screws from falling out.
Motor Size Winding Max Torque Current
Number inches Connection oz-in Amps
5014-842 1.38 x 1.38 x 1.57 4 lead 19 1.0
HT17-068 1.65 x 1.65 x 1.30 parallel 23 1.0
HT17-071 1.65 x 1.65 x 1.54 parallel 30 1.25
HT17-075 1.65 x 1.65 x 1.85 parallel 40 1.7
5023-122 2.22 x 2.22 x 2.0 parallel 60 2.0
5023-123 2.22 x 2.22 x 3.0 parallel 100 2.5
5023-124 2.22 x 2.22 x 4.0 parallel 150 3.5
HT23-394 2.22 x 2.22 x 1.54 parallel 60 2.8
HT23-397 2.22 x 2.22 x 2.13 parallel 140 2.8
HT23-400 2.22 x 2.22 x 2.99 parallel 180 2.0
5034-348 3.38 x 3.38 x 2.50 parallel 130 3.5