AXING SKP 2-10 User Manual
Page 13
Operation Instructions SKP 2-10
Chapter 3: Programming
16.02.12
© AXING AG • Swizzerland • Reserving change in design and type
13
Selection submenu Scan Satellite
Scanning satellites is very time consuming. If only certain programs are to be scanned, the option "Scan
Transponder" should be selected.
The menu item is activated by pressing the OK key.
Programs are searched in the selected satellite based on the settings of "Control Mode for Scan". When
selecting a certain LNB level, like Low horizontal etc. only this level will be scanned. Other settings, such
as Universal LNB, result in the entire satellite being searched.
The progress is shown in the lower part of the display. After completion, the message "Satellite searched"
appears. The new programs are saved at the end of the program list and can now be loaded.
Selection submenu LNB Control Mode
With VOL
/ VOL
, the desired LNB supply is selected. Either "Normal" or "Power off" can be
selected. In case of "Power off", all LNB settings are ignored. No control signals are generated.
If a Quattro LNB is connected, the LNB supply of all connected ducts must be set to "Normal".
Selection submenu Scan Transponder
The menu item is activated by pressing the OK key.
Transponder data are entered by means of the CH ▲ /CH ▼keys on the remote control.
A selection of parameters is pre-programmed. With VOL
/ VOL
, the desired parameter is selected.
Fig. 15: Scanning a satellite
Fig. 16: LNB Control Mode
Fig. 17: Submenu scan
transpondern