AXING SKP 2-10 - Manual (Page 9)

Operation Instructions SKP 2-10
Chapter 3: Programming
16.02.12 © AXING AG • Swizzerland • Reserving change in design and type 9
3.1 First start-up
During initial operation of the SKP 2-10 one must set first all output channels and the relevant TV
standard must be set!
3.1.1 Selecting duct left
To be able to program the left duct of the Twin module, the programming selection switch must be moved
to the left.
After pressing the UHF key on the remote control, a point lights up at the bottom right corner of the
display of the left duct.
This shows that the modulator is in programming mode.
A test image and test sound are switched on.
3.1.2 Setting output channel
By pressing the CH ▲ /CH ▼key, the desired output channel may be set.
Special channels are labeled by a 2nd dot between the digits on the display.
3.1.3 Setting TV standard
To set the TV standard, the SYS key (on the remote control) must be pressed until the desired TV
standard is set.
TV standard
Display
BG b6
I i
DK d
L l
NM mn
These settings must be saved with the OK key..
To discard settings, press the EXIT key. Programming mode is ended. Test image and test sound are
turned off.
After finishing the programming, the programming selection switch must be moved to the centre position.
Programming of the right duct is done identically as for the left duct.