AXING SKP 2-10 - Manual (Page 6)

Operation Instructions SKP 2-10
Chapter 2: Installation and connection
6 © AXING AG • Swizzerland • Reserving change in design and type 31.05.12
2
Installation and connection
The SKP 2-10 can either be operated in a headend basic unit SKS x-xx or in stand alone mode. SAT ZF
signals of the LNB(s) are either transmitted through a multiswitch or directly to SAT ZF inputs.
The maximum admissible current per SAT-ZT input is 250 mA.
2.1 Installation and connection in a headend base unit
If the SKP 2-10 should operate in a headend basic unit SKS x-xx, the twin module is plugged in the
output collection field c and fastened with screws. Each free slot may be used. The power supply of the
module is provided by the output collection field.
• For detailed information on the headend base unit, refer to whose operating instructions.
• Before inserting or changing a module, pull the mains plug of the headends basic unit from the socket!
Ground the base plate in order to avoid dangerous overvoltages according to EN 50083-1, EN 60728-
11:2010 (attention: risk of fire/death).
Important
Fig. 3: Installation and
connection in a headend
base unit
Notes