AXING SKP 2-10 - Manual (Page 7)

Operation Instructions SKP 2-10
Chapter 2: Installation and connection
31.05.12 © AXING AG • Swizzerland • Reserving change in design and type 7
2.2 Single operation mode of SKP 2-10
Before installing modules, the power supply must be switched off. Ground the module acc. to
EN 50083-1, EN 60728-11:2010 in order to avoid dangerous overvoltages (attention: risk of fire/death).
Use the grounding screw attached to the device (see 12 in Fig. 2).
When using the SKP 2-10 in single operation mode, the power is supplied via the DC socket (see 9 in
fig. 2 on page 5). A separate power supply unit SKZ 5-01
1 is required for it. More units are connected by
means of the DC loop-through. One DC connection cable SKZ 4-00 is included in the delivery of the
SKP 2-10. Max. 4 pieces SKP 2-10 may be connected together in single operation mode.
In single operation mode of the SKP 2-10 the outputs of the twin cassettes must be combined together
with splitters. The splitters (SKV 2..8-00) may be used in connection with F-double sockets (CFA 3-00).
1 SKZ 5-01 to supply up to 4 modules/SKZ 5-03 to supply up to 2 modules
Fig. 4: Assembly and
connection of a single twin
module
Fig. 5: Assembly and
connection of up to four twin
modules