CIRCUTOR CEM-C10 series - Manual (Page 21)

Figure 11: Validation screen�
After a few seconds viewing the screen shown on Figure 11 , the system returns to the Impulse
output weight programming main screen.
Minimum value: 99999.
Maximum value: 0.
Short press the key to access the next programming step
4�7�2� Impulse output type
The impulse output type is selected on this screen, between:
kWh or KVArh�
Short press the key to browse the different options.
To validate the data, long press the key and the validation screen will appear ( Figure 11 )
indicating that the programming value has been saved.
After a few seconds viewing the screen shown on Figure 11 , the system returns to the Impulse
output type programming main screen.
Short press the key to access the next programming step.
4�7�3� Peripheral address
NB : This is only displayed if there is a CEM M-RS485 (communications interface for the CEM
family of units) connected to the unit.
This is the home screen for entering the peripheral address.
Long press the key to view the value to be programmed.
21 Instruction Manual
CEM-C10