CIRCUTOR CEM-C10 series - Manual (Page 27)

To write or modify the value, short press the key repeatedly,
increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit with a long press on
the
key, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the key; the validation screen
will appear ( Figure 11 ) indicating that the programming value has been saved.
After a few seconds viewing the screen shown on Figure 11 , the system returns to the CO
2
emissions programming main screen.
Minimum value: 0.000
Maximum value: 9.000
Short press the key to access the next programming step.
4�7�10� Deleting the partial energy meters
NB: It is only displayed if the partial energy display has been selected.
On this screen you select whether or not to delete the partial
energy meters.
Long press the
key to delete the energy meters. The
validation screen ( Figure 11 ) will be displayed next, indicating that
the energy meters were deleted correctly.
After a few seconds viewing the screen shown on Figure 11 , the system returns to the Partial
energy meter deletion programming main screen.
4�7�11� Exiting the setup menu
When this screen is displayed:
Long press the
key to exit the setup menu.
Short press the key to return to the first setup point ( “4.7.1.
Impulse output weight” ).
27 Instruction Manual
CEM-C10