CUE uniCUE - Manual (Page 14)

14
Touch Panel Controllers / Mounting
© CUE, a.s. All Rights Reserved.
Hold touch panel in the upright position and
push it into the back box so that the thorns
in the back box slide into the grooves in the
metal slat of the touch panel. This enables you to tilt the panel, which holds
in this position, and mount cables.
If you want to place the panel in the back box,
hold it upright and push its bottom part stron-
gly as deep into the back box as possible. Then push the upper part of the panel until
the two metal catches slide into the fixing
tabs.
Note:
If the touch panel does not adhere to the wall
perfectly, you can adjust it as described in the
capture
Adjusting the Panel on the Wall.
Step 1 Step 2
Step 3 Step 4
Placing Unit Into The Back Box