d&b xA-Series - Manual (Page 10)

2.2.6. Z5416 Connector plate 10A
The connector plate is used to interconnect 10A (-D) cabinets and
set them to different splay angles.
Splay angles between adjacent cabinets can be set in the range
from 25° to 60° in 5° steps.
Note: When setting up horizontal arrays consisting of 10A (-
D) cabinets, set the minimum splay angle between adjacent
cabinets to 30° to allow for the attachment of the Z5419
Load bar xA or Z5415 Flying bar adapter xA as supporting
and suspension device.
2.2.7. Z5417 Connector plate 10AL
Intended use
The connector plate is used to interconnect 10AL (-D) cabinets and
set them to different splay angles.
Splay angles between adjacent cabinets can be set to 0°, 1°, 2°,
4°, 6°, 9°, 12° or 15°.
Note: The connector plate can also be used in a mixed
vertical array when adding 10A (-D) cabinets below a SUB
cabinet.
2.2.8. Z5418 Connector plate xA-SUB
Intended use
The connector plate is used to interconnect xA-SUB cabinets and
allows splay angle settings between adjacent SUB cabinets of 0°,
2.5° or 5°.
d&b xA-Series, Rigging manual (1.1 EN) 10