Assembly procedure – d&b xA-Series User Manual
Page 19
4.3.1.1. Assembly procedure
Joining the cabinets together
The procedure applies to both sides of the cabinets.
1. Place the cabinets with their side panels next to each other in
the right order and with the right orientation of the HF sections.
2. Remove the cover panels.
3. Attach the respective connector plates and set the desired
splay angles.
4. Refit the cover panels and tighten the screws to a torque of
12 N·m.
5. Recheck your work.
6. Carefully turn the array through 180°.
Þ Depending on the size (length) of the array, a second
person should assist you.
7. Complete the assembly by proceeding in the same manner.
8. Carefully turn the array over onto the front of the cabinets.
9. Recheck all your work:
–
Check the splay angles.
–
Ensure all screws are properly tightened.
Þ The array is now ready for the attachment of the desired
suspension device.
d&b xA-Series, Rigging manual (1.1 EN)
19