d&b xA-Series - Manual (Page 9)

2.2.4. Z5415 Flying bar adapter xA
Scope of supply
Qty. d&b Code Description
1
Z5415 d&b Flying bar adapter xA [2]
Including:
2 Pan head bolt M8 x 16, torx T45 [2.1]
2 Self-securing nut M8 [2.2]
Intended use
The Flying bar adapter xA is used in conjunction with the Z5414
Flying bar xA and allows single or dual pickpoint operation.
It is attached to the flying bar by simply sliding it onto the bar and
fixing it at the center position using the pan head screws [2.1] and
self-securing nuts [2.2].
The flying bar also allows the attachment of two flying bar
adapters at each end of the bar, which are fixed using one pan
head screw [2.1] and self-securing nut [2.2] for each adapter.
A detailed description of the various suspension options is given in
Þ Chapter 3. "Suspension options" on page 15.
2.2.5. Z5419 Load bar xA
Scope of supply
Qty. d&b Code Description
1
Z5419 d&b Load bar xA [3]
Including:
2 Spring washer [3.1]
2 Pan head bolt M8 x 18, torx T45 [3.2]
2 Q9031 M8 Safety eyebolt [3.3]
Intended use
The Z5419 Load bar xA can be used in different ways:
– as supporting device instead of using the Z5414 Flying bar
xA.
– to suspend vertical arrays in conjunction with the Z5420 Load
eye bolt.
– as supporting device for horizontal array configurations in
conjunction with the supplied Q9031 M8 Safety eyebolt.
– to attach a second pickpoint between adjacent cabinets in the
lower part of the array or at the end of the array acting as a
pullback anchor device together with the Z5420 Load eye
bolt, if required.
– to attach a second pickpoint to fix the horizontal aiming of the
array using the Q9031 M8 Safety eyebolt and appropriate
steel wire ropes.
A detailed description of the various suspension options is given in
Þ Chapter 3. "Suspension options" on page 15.
d&b xA-Series, Rigging manual (1.1 EN) 9