d&b xA-Series - Manual (Page 8)

NOTICE!
Risk of damage to the rigging components.
When using the additional suspension hole of the connector plate
to suspend and/or lash the array, the Z5414 Flying bar xA must
be used as supporting device between the two connector plates.
Alternatively, the Z5419 Load bar xA can be used for this
purpose. It is recommended to attach the load bar to the rear
fixing hole of the connector plate as shown in the graphic
opposite.
A detailed description of the various suspension options is given in
Þ Chapter 3. "Suspension options" on page 15.
2.2.3. Z5414 Flying bar xA
Scope of supply
Qty. d&b Code Description
1
Z5414 d&b Flying bar xA [1]
Including:
4 Spring washer [1.1]
4 Pan head bolt M8 x 18/12.9 [1.2] (torx
#T45)
Intended use
CAUTION!
Risk of damage to the rigging components.
Only use the supplied and specified pan head bolts [1.2] with a
quality grade of 12.9.
The Flying bar xA is used to suspend xA arrays with the following
options:
– Either single or dual pickpoint operation in conjunction with
the Z5415 Flying bar adapter xA. In this combination the
flying bar can be attached in two directions to provide an
extended hole grid using the flying bar adapter.
– Dual pickpoint operation in conjunction with the Z5413 Flying
bar connector plate xA.
– It can also be used to attach a second pickpoint between
adjacent cabinets in the lower part of the array or at the end
of the array acting as a pullback anchor device, if required.
– The flying bar is also used as supporting device for horizontal
array configurations in conjunction with the Q9031 M8
Safety eyebolt.
A detailed description of the various suspension options is given in
Þ Chapter 3. "Suspension options" on page 15.
d&b xA-Series, Rigging manual (1.1 EN) 8