Desa VTGF33NRA - Manual (Page 20)

www.desatech.com 110112-01C 20
5. Locate hole on bottom of log #5 and place
over pin on log #2. Log #5 will rest on back
of log #1 (ember bed). See Figure 34.
6. Place log #6 onto two pins on log #1 (ember
bed) and rest back of log #6 on back log #4
(see Figure 34).
INSTALLATION
Continued
Figure 33 - Installing Log #4
Log #2
Log #3
Log #1
Log #4
INSTALLING BATTERY INTO
REMOTE
1. Locate slot at bottom of remote control (see
Figure 35). Firmly insert tool such as a small
screwdriver, butter knife, or dime into the slot
and lift up to remove cover.
2. Insert supplied battery into remote control.
Positive and negative are marked inside re-
mote control casing. Note: Remote will not
function if battery is not installed correctly.
3. Slide tab on cover into remote housing and
snap cover back into place.
IMPORTANT: Use only A23 12 volt battery in
remote. DO NOT use AAA battery.
Figure 34 - Installing Log #5 and Log #6
Log #6
Log #5
Log #2
Log #4
Log #3
Log #1
Positive
Figure 35 - Installing Battery
Negative
Tab
Cover
Remote
Control
Slot
A23 12
Volt
Battery
Figure 36 - Installing Fireplace Screen
INSTALLING SCREEN
Install fireplace screen by slipping notches of
fireplace screen over screws on front of fireplace
(see Figure 36).
Notches
Screws
for
Mounting
Screen