Future Automation PSE90 - Manual (Page 13)

Installation:
Electrical connection
+ ( + ( Page 1 2 of 17 // email [email protected] tel: 44 0) 1438 833577 fax: 44 0) 1438 833565
PSE90 Flat Screen Electric Wall Mount
Contact Closure
Use an RJ45 connector in the
CCI socket on the control box
to operate via contact closure
  SLQV
LED 1
LED 2
LED 3
LED 4
LED 5
CONTACT CLOSURE INPUT
NOTE:
Earlier versions of the control board
may not have these contact closure
LED indicators.
568A 568B
1 12V SUPPLY 12V SUPPLY - CURRENT LIMITED W/G W/O
2 12V LATCH
When 12V attached, device will go OUT to PRESET
position. When 12V removed, device will go IN.
G O
3 GROUND GROUND W/O W/G
4 DEVICE LATCH
Short to GROUND (pin 3), device will go OUT to PRESET
position, remove short device will go IN.
BL BL
5 PIN 4 NOT USED W/BL W/BL
6 DEVICE STOP
Momentary short to GROUND (pin 3), stops device in
current position.
O G
7 DEVICE OUT
Momentary short to GROUND (pin 3), makes device go
OUT.
W/BR W/BR
8 DEVICE IN
Momentary short to GROUND (pin 3), makes device go
IN.
BR BR
PIN DESCRIPTION ACTION
WIRE / CABLE