Future Automation PSE90 - Manual (Page 8)

Page 7 of 17 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PSE90 Flat Screen Electric Wall Mount
Installation:
Stage
3
Opening the mechanism prior to fitting
Before fitting the mechanism to the wall, it will need to
be opened to allow access to the wall plate. This must
be done as per these instrutions to avoid damage to
the mechanism.
1 - Hold the PSE90 by the wall plate,
upside down (link arm underneath as
shown) on a soft, non-abrasive
surface that is free from any
obstructions.
2 - Make sure the power is
connected and press the "Home"
button on the remote control. This
will open the bracket to 45 degrees.
3 - Remove the power and turn the
PSE90 the correct way up, before
fitting onto the wall as shown on
the next page.