Future Automation PSE90 - Manual (Page 14)

Page 1 3 of 17 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PSE90 Flat Screen Electric Wall Mount
Installation:
RS232
Step 1 Step 2
fa_in Device IN
fa_out Device OUT
fa_stop Device STOP
fa_store fa_(preset, home,A-F) Store memory position
fa_preset Device to stored memory position
COMMAND
ACTION
Operation Details
DC1
Low voltage power output for
motor drive.LED’s to show
operation of limit switches
and positional counters
Details
Baud rate: 9600
Stop bit:
1
Parity: None
Databits: 8
IMPORTANT
Ensure protocol is entered exactly as written, including
Carriage Return (Enter / ASCII 13). After pressing
STORE you have a 2 second window to select your
save button, after 2 seconds the command is void.
Mains Voltage Input
IR LED
IR Input
Jack
RS232
Contact Closure
 

 

 


SLQV
RS232
- Use an RJ25 connector in the socket marked
RS232 on the control box to operate using RS232
Pin 1: RX
Pin 6 : TX
Pin 3 & 4: GROUND
Pin 2: TX
Pin 3: RX
Pin 5: GROUND
RJ25 9 PIN D
PIN 1: RX TO PIN 2: TX
PIN 6: TX TO PIN 3: RX
PIN 3: GROUND TO PIN 5: GROUND
PIN 4: GROUND TO PIN 5: GROUND