Paxton Superchargers Small Block Carbureted Ford - Manual (Page 26)

8-2
P/N: 4PFX020-010
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
26JAN07 v2.1 UnivSBFCarb(4PFXv2.1)
Fig. 8-e
Fig. 8-f
Fig. 8-h
Fig. 8-g
H. Install two of the brass plugs in each side of
the carburetor enclosure. (See Fig. 8-g.)
I. Install the idle bracket on the outside of the
enclosure using two 1/2" screws. (See Fig.
8-h.) Install the supplied 10-32 jam nut on
the 1" 10-32 screw and insert into the idle
bracket. Alternatively, the idle can be adjust-
ed at the carburetor before the enclosure
cover is installed.
J. With the one armed throttle arm on the
inside of the enclosure, insert the splined
shaft through the throttle bushing on the side
of the carburetor enclosure.
K. Install the large brass spacer over the splined
shaft until it rests flat against the outside of
the enclosure. (See Fig. 8-h.) Line up the
remaining throttle arm with the inner throttle
arm and slide onto the splined shaft.
SPACER
L. Tighten the clamp screws on both of the
throttle arms. Rotate the throttle linkage to
verify free movement. If drag is felt, adjust
the distance between the two throttle arms.
M. Install the remaining rod end on the outer
hole on the inside of the inside throttle arm
and tighten screw.
N. Install the carburetor over the carburetor
studs until it sits flat on the gasket. Install
the four 5/16" nuts and washers on the studs
and tighten. Make sure unused vacuum ports
on the carburetor are plugged.