Paxton Superchargers Small Block Carbureted Ford - Manual (Page 31)

10-1
P/N: 4PFX020-010
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
26JAN07 v2.1 UnivSBFCarb(4PFXv2.1)
Section 10
FINAL RE-ASSEMBLY AND CHECK
10.1 FINAL REASSEMBLY AND CHECK
*** WARNING ***
Do not attempt to operate the vehicle until all compo-
nents are installed and all operations are completed
including final check.
A. Reconnect the battery.
B. If your vehicle has gone over 15,000 miles
since its last spark plug change, you will
need to change the spark plugs now before
test driving the vehicle.
C. Check all fittings, nuts, bolts and clamps for
tightness. Pay particular attention to oil and
fuel lines around moving parts, sharp edges
and exhaust system parts. Make sure all
wires and lines are properly secured with
clamps or tie-wraps.
D. Check all fluid levels, making sure that your
tank(s) is filled with 91 octane or higher fuel
before commencing test drive.
E. Start engine and allow to idle a few minutes,
then shut off.
F. Recheck to be sure that no hoses, wires, etc.
are near exhaust headers or moving parts
and for signs of any fluid leakage. Re-jet the
carburetor as required. Install a boost refer-
enced high-performance mechanical fuel
pump or high performance electric fuel
pump with boost referenced fuel regulator.
Check ignition timing to make sure it is
properly set before commencing test drive.
G. PLEASE TAKE SPECIAL NOTE:
Operating the vehicle without all sub
assemblies completely and properly
installed and working may cause FAIL-
URE OF MAJOR ENGINE COMPO-
NENTS.
H. Keep in mind that this manual does not
address air/fuel or ignition timing considera-
tions. (See Page iv.)
I. Test drive the vehicle.
J. Read the Street Supercharger System
Owner's Manual and RETURN THE
Warranty REGISTRATION FORM within
thirty (30) days of purchasing your super-
charger system to qualify.
Fig. 10-a / Passenger side installation.
('64-'68 Mustang)
Fig. 10-b / Driver side installation.
('64-'68 Mustang)