Paxton Superchargers Small Block Carbureted Ford - Manual (Page 28)

8-4
P/N: 4PFX020-010
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
26JAN07 v2.1 UnivSBFCarb(4PFXv2.1)
Fig. 8-l / Carburetor enclosure
(64-68 Mustang shown)
THROTTLE
CABLE
BRACKET
O-RING
NUT
BULKHEAD
FITTING
DEMON THROTTLE
ASSEMBLY SETUP
(INVERTED INNER
THROTTLE ARM)
HOLLEY THROTTLE
ASSEMBLY SETUP
(STANDARD INNER
THROTTLE ARM)
.130"
SPACER
T. Install the throttle return spring.
U. Check for full throttle by pressing the accel-
erator to the floor and verifying that the car-
buretor butterflies open fully.
V. If possible, pressurize the fuel system and
check for leaks.
W. Using the supplied 5/16" cap screws, install
the top cover on the enclosure and tighten
the screws.
X. Use the supplied hardware to plug any open
holes in the carburetor enclosure and cover.