Paxton Superchargers Small Block Carbureted Ford - Manual (Page 27)

8-3
P/N: 4PFX020-010
©2007 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
26JAN07 v2.1 UnivSBFCarb(4PFXv2.1)
Fig. 8-i
Fig. 8-j
Fig. 8-k
1. Install the -8 bulkhead nut and O-ring
on the bulkhead fitting.
2. Thread the bulkhead fitting into the
front hole in the carburetor enclosure.
3. Install the fuel lines into the carburetor
bowls loosely.
4. Connect the free end of each fuel line to
the -8/-6/-6 TEE.
5. Install the -8 straight hosebarb fitting on
the inside of the bulkhead fitting. Install
the -8 120° fitting on top of the TEE.
6. Measure and cut the supplied pushlock
hose so that it will fit well between the
two installed barb fitttings.
7. Remove the barbed fittings, coat the
barbs with grease, and fully insert the
barbed fittings in the hose.
8. Install the fuel hose assembly and tight-
en all of the fuel line connections.
Q. Hose connections to the carburetor enclo-
sure will vary widely depending on the
application. All holes that are not used
should be plugged with the supplied -3, -8
and 1/4"NPT plugs.
*** NOTE ***
All -3 and -8 fittings should have an O-ring installed
before using.
R. Connect the hose previously attached to the
small barb fitting on the fuel pump to a -3
bulkhead fitting in the enclosure. Leave the
O. With a jam nut installed on each rod end,
install the 5/16" coupler shaft between the
two rod ends. Adjust the coupler until the
angle of the carburetor enclosure throttle
arm matches that of the carburetor throttle
arm.
P. Install the fuel lines on the carburetor (See
Fig. 7-i.) as follows:
bulkhead fitting open on the inside of the
enclosure.
S. For Mustangs, use the model specific exter-
nal throttle linkage. All other applications
must have a suitable throttle actuation
assembly fabricated.
1. 1964-1968 Mustang: Install the supplied
2" tapered spacer onto the factory throt-
tle arm using the supplied 3/8-16 screw
with two washers under the head. With a
rod end in each end, install the supplied
6" throttle shaft. (See Fig. 8-j.)
2. 1969 Mustang: Install the supplied throttle
bracket onto the rear of the enclosure using
two 10-24 x .5" screws. Install the L-bracket
onto the throttle bracket using two 10-24 x
.5" screws and nuts. Install the throttle cable
in the factory manner through the “L” brack-
et and attach to the throttle arm using the
suppled ball mount. (See Fig. 8-k.)