Vectronics VEC-121K - Manual (Page 20)

VEC-121K Owner's Manual Crystal Radio Set Kit
18
Only a few more steps remain, and the set will be finished.
Refer to the drawing below for the last wiring steps.
DET2
EAR1
! Cut a 4½” length of 18 AWG enamel wire from the wire spool in the kit.
! Remove 1” of insulation from each end.
! Form each end of the wire into an end connection.
! Loosen the screws mounting the Fahnstock clips DET2 and EAR1.
! Take one of the wire end connections and place between the DET2 clip and
breadboard.
! Tighten the mounting screw for the DET2 clip until snug.
! The remaining end connection is placed between the EAR1 clip and
breadboard.
! Tighten the mounting screw for clip EAR1 until snug.