Vectronics VEC-483K - Manual (Page 16)

VEC-483K Owner’s Manual Voice Activated Tape Recorder Switch
16
ENCLOSURE
To install your Voice-Activated Tape Recorder Switch in the VEC-483KC
matching enclosure follow these instructions (read all instructions before
beginning ... take your time):
1. Find the front panel decal and trim. Be sure to leave excess decal material
around the edges. Put the front panel decal on. This is done by: a.)
Remove all debris and oil from the face plate. This should be done using a
piece of cloth and alcohol. b.) Remove the crack and peel to expose the
adhesive. c.) Place the decal on the front panel without securing it
completely. d.) Gently rub the alignment circles with your finger--if the
circles are centered in the enclosure holes (also check the corner alignment
marks) secure the decal by rubbing and removing all air bubbles. e.) If the
alignment circles are not centered, adjust the decal accordingly, then secure.
f.) Use a penknife, or small Exacto
TM knife, to cut away the unused edges (cut
from the adhesive side) and cut out the component holes (cut from the
description side).
2. Now insert the PC board. This must be done by: a.) Insert the front of the
PC board into the metal faceplate with the jacks in their respective holes. b.)
Place the nuts onto the jacks and tighten. Ensure that the switch and the
microphone are aligned properly. c.) Install the red switch cap on the power
switch (SW1).
3. Slide the face plate in the slots at the end of the bottom portion of the
enclosure. Loop the battery snap through to the battery compartment. Now
place the top portion over the bottom ensuring that the face plate slides into
the slots. Secure the two enclosure portions together with the two mounting
screws.
4. Finally, place a 9V battery into the battery compartment and attach to the
battery snap. Make sure the power switch is off before installing the battery.