WaveWare comPPage PIA-3264 - Manual (Page 21)

Paging Interface Adapter
21
OPERATION
1. Voltage Input
2. Voltage Alert High
3. No pulsing
4. No Shift
The system will continually scan all contacts at the rate of 1.5m/s. It senses a change on contact 1, the
voltage went from zero volts to +24vdc. The program will check the global programming parameters to
see if Shift, Monitor pagers are selected. If Shift is selected, it will check the clock and see what time the
alarm was activated, then compare that to the Shift schedule. This will determine what pager it pages. It
will select the Active Message and place it in the correct paging protocol that was selected on the Global
Setting page. Since this example Shift was not selected. The system will use the pager ID in Shift 1 entry.
SEARCH and DISPLAY DATA
Find Room
1. Enter the room number you want to find in the field next to Room No..
2. Select Find Room.
3. All programming for that specific room will be displayed.
Find Zone
1. Enter the zone number you want to find in the field next to Find Zone
2. Select Find Zone.
3. All programming for that specific zone will be displayed