WaveWare comPPage PIA-3264 - Manual (Page 4)

Paging Interface Adapter
PAGING INTERFACE ADAPTER
PIA3264
PAGING INTERFACE ADAPTER
The Paging Interface Adapter unit is an alarm contact input device with 16 inputs and upgradeable to 64. The unit is
programmable by the user, using Microsoft™ Web browser program. Each unit has it own IP address. Simply enter
the IP address on the address line. All data is password protected. The PIA can be programmed from a stand alone
PC with an Ethernet card using a supplied RJ45 Crossover cable, or over the Local Area Network or any where from
the Internet.
The PIA has an added protection of sending a health check page every 2 minutes to alert the user the system is
operating properly.
The PIA will accept Dry (no voltage) contact closure or Voltage, high or low, input. Voltage input range is 6 to 50
volts AC or DC. Each input is fused to protect the inputs in case voltage is applied to a contact input that has been
configured for no voltage. Each contact can be configured for a different individual pager ID (cap code), Alert type
(A, B, C, or D) and repeats ranging from none, 1-4, or until Change of State. Time interval between repeats can be
select from 1 minute to 59 minutes. The paging protocol is a global setting of either Scope
™ , Motorola ™ TAP v1.8,
COMP2 and
WaveWare
™. In addition the PIA supports shift changes, escalation of pages and 2 pulse rates.
The PIA can be daisy chained together via RS485 Cat 5 RJ45 cabling to support up to 576 contact inputs.
comPPage’s Paging Interface Adapter (PIA3264) is a unit that was Designed, Developed and Manufactured in the
USA. Each unit has a Limited Lifetime Warranty.
4