D-Link DI-1162M - Manual (Page 110)

DI-1162/DI-1162M Remote Access Router
104
The parameters are described as follows:
♦
IPX Net – This is the IPX network number.
♦
Node Address – This is the node address of the device that the router will attempt to reach. The router will
check its routing table and try to locate the IPX Address.
♦
Count – The number of pings (packets) that will be sent.
♦
Delay (1 sec) – The amount of time in 1 second intervals between each ping in the Count.
♦
Start Ping Test - Press <Enter> or <Return> to begin the test.
System LAN
The System LAN test is used to diagnose the LAN port. It can only be run if the LAN port is disabled in the
Interface Configuration submenu.