D-Link DI-1162M - Manual (Page 89)

DI-1162/DI-1162M Remote Access Router
83
Host Table
The host table allows the router to recognize host names on the network. Up to eight host names can be entered in
the table. Your network servers, especially your mail server should be defined here. Leftover places in the table
can be assigned to individual hosts to speed up routing.
In the example below, the host name ctsnow is combined with the domain name defined in the DNS
Configuration submenu above (in this case, dlink.com) to produce ctsnow.dlink.com. The mapping in the
example of ctsnow.dlink.com to the IP Address of 11.1.1.3 is only valid for computers which set the
DI-1162/DI-1162M router as their DNS server.
Items are described as follows:
♦
IP – The IP address for the host.
♦
Host Name – The host name used by the host.
♦
State – Enables or disables entry.
RADIUS Configuration
RADIUS is a password protocol where passwords are stored on a RADIUS server. RADIUS allows large numbers
of passwords to be stored in a centralized location. Before instituting RADIUS, please setup and install a RADIUS
server on the LAN.