D-Link DI-1162M - Manual (Page 119)

DI-1162/DI-1162M Remote Access Router
113
TCP/IP Parameters Configuration Menu
The parameters are described as follows:
♦
Interface – The LAN interface must use Ethernet/Fast Ethernet and is displayed here. This setting cannot be
adjusted.
♦
IP Address – This is the router’s IP Address for the LAN interface.
♦
Subnet Mask – This mask shows how the LAN is to be divided into network, subnet, and host parts.
♦
Default Gateway – This is the default gateway for the LAN. If this router will be the default gateway for the
LAN, then the address should be 0.0.0.0.
♦
Send BootP request upon power up – If set to Yes, when the router boots up, it will attempt to acquire the
path to the image file, the TFTP server IP Address and the routers own IP Address.
System Reset
The system reset function enables you to reset the DI-1162/DI-1162M without powering off. Some settings
changes require a system reset in order for them to take effect.
A system reset will not affect the router’s settings, but will clear all tables including the routing table and all
SNMP counters and tables. It is also used to initiate a software update.