AMETEK DCS-E 3kW Series - Manual (Page 30)

Installation Sorensen DCS-E Series 3kW Supplies
2-6 M362295-01 Rev C
C ONTACT I NSTALLATION
5. Insert contact with attached wire into the connector until lock snaps into place. See
Figure 2-3 and Figure 2-4 to complete the connector for either single or three phase
input.
Figure 2-3 Contact Orientation
Figure 2-4 AC Wire Locations
2.5.4 Strain Relief Assembly
The strain relief is assembled from supplied pieces and attaches to the AC input connector to
provide support for the AC input cord.
P ARTS S UPPLIED
• Two (2) pieces strain relief Part number MI-6432-661, Tyco 643266-1
•
Two (2) screws Part number MS-6PPS-10 (screw #6-32, 5/8” long, self tapping)
A SSEMBLY I NSTRUCTIONS
1. Snap off the rectangular bushing attached to each piece of the strain relief.
See Figure 2-5.
2. Install bushings on strain relief pieces, if required:
If cable diameter is within 0.1" to 0.4", install bushings.
If cable diameter is within 0.5" to 0.74", do not use bushings.