AMETEK DCS-E 3kW Series - Manual (Page 45)

M362295-01 Rev C 4-1
SECTION 4
ADVANCED OPERATION
4.1 INTRODUCTION
All DCS-E Series power supplies offer the following standard features:
• Remote Programming of Output Voltage and Current Limit with 0-5V, 0-10V, 0-1 mA,
and 0-5k ohms (Section 4.3)
•
Overvoltage Protection (OVP) with front panel controls or 0-5V and 0-10V programming
(Section 4.4)
• Programmable Shutdown with AC, DC, or TTL compatible signals and contact closure
(Section 4.5)
• Remote Monitoring of Status Indicators for thermal shutdown, OVP status, remote/local
programming mode, and voltage/current mode operation (Section 4.6)
• Calibrated Readback Signals for output voltage and output current with selectable 0-5V
or 0-10V scales (Section 4.6)
•
Multiple Supply Configurations such as series, parallel, and split supply (Section 4.7)
• Remote Voltage Sensing (Section 3.3)
• Output Voltage Biasing (Section 4.8)
Accessing these features may require that you use one or more of the following procedures:
• Using the front panel REM/LOC (Remote/Local Programming) switch.
• Reconfiguring the rear panel J3 connector.
•
Making connections to the J3 connector.
• Resetting internal jumpers JMP1 and JMP2.
• Resetting internal switch SW1.