AMETEK HPD Series GPIB-Multichannel - Manual (Page 111)

SCPI Com
m
an
d Refer
e
nce
SCPI Co
mmand Summary
Release A
10
7
Table B.4Commands for Current Share
Table B.5Commands for Calibration
Table B.6Command to Clear all Protection Mechanisms
Set High Voltage Limit [[:]SOURce][<channel>]:VOLTage:LIMit:HIGH
{<voltage>|MAXimum|MINimum}
Set upper limit of voltage setpoint range (soft
limits) Yes
Set Low Voltage Limit [[:]SOURce][<channel>]:VOLTage:LIMit:LOW
{<voltage>|MAXimum|MINimum}
Set lower limit of voltage setpoint range (soft
limits) Yes
Function SCPI Command Description Query
Set Current Sharing Mode [[:]SOURce][<channel>]:COMBine:CSHare:MODE
{NONE|MASTer|SLAVe}
Select current share mode Yes
Read Summed Current [:]MEASure[:SCALar]:CURRent[:DC]? SUM Read total current output of all current
sharing supplies N/A
Function SCPI Command Description Query
Restore Factory
ion [:]CALibration[<channel>]:RESTore Restonres the calibration to the constants set
at the factory N/A
Change Calibration
Password [:]CALibration[<channel>][:SECure]:CODE <codeword> Changes the calibration security code. No
Set Calibration State [:]CALibration[<channel>][:SECure]:STATe
<on-off-state>,<codeword> Change calibration state (mode) Yes
Set Supply Output Current
Level [:]CALibration[<channel>]:OUTPut:CURRent:LEVel
{MINimum|MAXimum}
Set output current calibration level No
Enter Output Current Data [:]CALibration[<channel>]:OUTPut:CURRent[:DATA]
<current>
Set output current calibration data No
Set Supply Output Voltage
Level [:]CALibration[<channel>]:OUTPut:VOLTage:LEVel
{MINimum|MAXimum}
Set voltage output calibration level No
Enter Output Voltage Data [:]CALibration[<channel>]:OUTPut:VOLTage[:DATA]
<voltage>
Set voltage output calibration data No
Function SCPI Command Description Query
Clear Output Protection [:]OUTPut[<channel>]:PROTection:CLEar Clears the protection mechanism. N/A