AMETEK HPD Series GPIB-Multichannel - Manual (Page 116)

11
2
Oper
ating
Manual
for Multichanne
l F
unctionality (
G
PIB-
M)
SCPI Command Re
fe
rence
SCPI C
o
mman
d Summary
Table B.11Protection Commands
Table B.12User Lines
Table B.13Output State
Query the Standard Event
register (ESR?) [:]STATus[<channel>]:STANdard[:EVENt]? See Table 4.10, on page 78. N/A
Enable the Standard
Event register
(*ESE,*ESE?) [:]STATus[<channel>]:STANdard:ENABle See Table 4.10, on page 78. Yes
Query the Status Byte
(*STB) [:]STATus[<channel>]:SBYTe[:EVENt]? See Table 4.11, on page 79. N/A
Service Request Enable
(*SRE,*SRE?) [:]STATus[<channel>]:SREQuest:ENABle <status-enable> Set the bits in the Service Request Enable
Register. Yes
Function SCPI Command Description Query
Set Over Temperature
Response [:]SENSe[<channel>]:TEMPerature:PROTection:LATCh
<on-off-state>
Select if output is latched off or auto
recovers in the case of an over temperature
condition Yes
Query Over Temperature
Protection Tripped [:]SENSe[<channel>]:TEMPerature:PROTection:TRIPped? Query temperature protection tripped N/A
Set AC Fail Response [:]SENSe[<channel>]:VOLTage:AC:PROTection:LATCh
<on-off-state>
Select if output is latched off or auto
recovers in the case of an AC Fail Yes
Query AC Fail Protection
Tripped [:]SENSe[<channel>]:VOLTage:AC:PROTection:TRIPped? Query AC protection circuit tripped N/A
Function SCPI Command Description Query
Select polarity of Auxiliary
Lines [:]OUTPut[<channel>]:AUXiliary<A|B>:POLarity
{HIGH|LOW}
Configure the polarity of the auxiliary line Yes
Select Source of Auxiliary
Line State [:]OUTPut[<channel>]:AUXiliary<A|B>:SOURce
<aux_line_mnemonic>
Configure the auxiliary line Yes
Query state of Auxiliary
Line [:]OUTPut[<channel>]:AUXiliary<A|B>:STATe? Query the state of the auxiliary line N/A
Function SCPI Command Description Query
Set Output State [:]OUTPut[<channel>][:STATe] <on-off-state> Enable/disable the power supply output. Yes
Set Output State at
Power-On [:]OUTPut[<channel>]:PON:STATe <on-off-state> Selects the state of the output at power-on Yes
Power-On Configuration [:]OUTPut[<channel>]:PON:RECall
{PRESet|USER<setting_location>|SEQ<sequence_number>}
Configure the supply to recall last setting,
one of the user settings, factory preset
values or to enable an auto sequence. Yes