AMETEK SFA Series Ethernet Programming User Manual
Page 86
SCPI Command Operation
SG Series Programming
6-14
M550129-03 Rev K
Command
Description
SCPI
:RAMP <NRf> <NRf>
Sets the output current to ramp from the present value to the
specified value (first argument) in the specified time (second
argument). See Ramp Function description below.
N
:RAMP?
Returns 1 if the ramp is in progress, and 0 if the ramp is
completed.
N
:ABORt
Aborts ramping and clears trigger mode.
N
:ALL?
Returns the ramping status of all channels.
N
:HTRIGgered <NRf>
Sets the value of the output current to ramp to be
implemented when the hardware trigger is received.
N
:HTRIGgered?
Returns the value of the output current to ramp to be
implemented when the hardware trigger is received.
N
:TRIGgered <NRf>
<NRf>
Sets the output current to ramp from the present value to
the specified value (first argument) in the specified time
(second argument) upon the trigger command. See Ramp
description below.
C
:TRIGgered?
Returns the value that the output current is to ramp to (first
value) and the time that it is to ramp (second value) upon
the trigger command.
C
:TRIGgered
Sets the output voltage to the values stored by the
SOURce: CURRent:TRIGger:AMPLitude command.
C
:TRIGgered?
Returns the current level that will be set upon receipt of the
trigger.
C
:CLEar
Clears the value stored by the
SOURce:CURRent:TRIGger:AMPLitude command.
C
:AMPLitude <NRf>
Stores the value of the output current to be set when the
SOURce: CURRent:TRIGGered command is sent.
C
:AMPLitude?
Returns the stored value of the output current to be set
when the SOURce: CURRent:TRIGGered command is
sent.
C
:POWer
(in SGI only); see Section 6.13.2.
C
:POWer?
C
:TIMeout?
Returns the integer value 1 (timeout since last query) or 0
(no timeout) of the timeout status of the channel.
N
:VOLTage
Sets the output voltage of the supply in volts (default) or in
millivolts.
C
:VOLTage?
Returns the output voltage of the supply in volts or in
millivolts.
C
[:LEVel]
Sets the output voltage of the supply in volts (default) or in
millivolts.
C
[:LEVel?]
Returns the output voltage of the supply in volts or in
millivolts.
C