AMETEK SLD Series - Manual (Page 26)

Installation Sorensen SLD-Series DC Load
2-4 M540075-01 Rev C
Figure 2-3 Single Bay, Dual Input Electronic Load Module Plug-in and Removal
Figure 2-4 Dual Bay Electronic Load Plug-in and Removal
2.2
Input Binding Post and Wire Considerations
There are five ways that binding posts (+, com and -) can connect the input wires to the
Electronic:
2.2.1 Plug Connectors
This is the most popular way to connect the input of electronic load to the device under test.
It is recommended the load current be less than 20A in this connection since the current
rating of the plug is rated to 20A. The maximum wire gauge should be limited to AWG14.