Artesyn COMX-P40x0 ENP2 Installation and Use (August 2014) - Manual (Page 116)

BSP
COMX-P40x0 ENP2 Installation and Use (6806800R95B) 116
Commands
1. Build by default

make kernel dtb
2. Build Targets supported for Linux kernel
 config-default
: copies the COMX-P4080 default configuration to current
configuration
 kernel-config
: configures the kernel based on current configuration
 kernel
: compiles kernel with current configuration
 kernel-clean
: cleans the kernel
 dtb
: compiles device tree binary
Output
The build images are uImage and comx.dtb in the current working directory.
7.21.3 Build ROOTFS
The rootfs for SCP-P4080-2G-ENP2 include RAMDISK and NFS.
Commands
1. make rootfs: The output image is /local/tmp/<username>/rootfs_ext2.img.
2. Build Targets supported for rootfs
 rootfs
: builds rootfs
 rootfs-ext2
: builds rootfs for ram disk
 rootfs-nfs
: builds rootfs for nfs
 rootfs-clean
: clean the rootfs
Output
The build images are rootfs_ext2.img and rootfs_nfs.tar.gz in the current working directory.