Artesyn COMX-P40x0 ENP2 Installation and Use (August 2014) - Manual (Page 16)

Introduction
COMX-P40x0 ENP2 Installation and Use (6806800R95B) 16
 Tamper detect pin to the COME connectors
 On-board RTC and WDT device
 Provide both remote and local thermal sensor
 JTAG connector on module
 Aurora testing points on module
 12V power supplied to module through COME connectors
 5V standby power from COME connector not required/used by module
1.2 Standard Compliances
The product is designed to meet the following standards.
Due to P4080 errata GEN-A009, Aurora ports are disabled by default in RCW and must be
re-enabled for debug. For assistance, contact Artesyn representative.
Table 1-1 Standard Compliances
Standard Description
UL60950-1 EN 60950-1 IEC
60950-1 CAN/CSA C22.2 No
60950-1 Safety Requirements
UL/CSA 60950-1
EN 60950-1
IEC 60950-1 CB Scheme Legal safety requirements
FCC 47 CFR Part 15 Subpart B
(US), Class A
EN55022 Class A (EU)
AS/NZS CISPR 22 Class A
(Australia/New Zealand)
VCCI Class A (Japan) EMC requirements (legal) on system level
(predefined Artesyn system)