Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 28)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 28
/dev/sda8 21265+ 76316- 55051- 56372084+ 83 Linux
New situation:
Units = mebibytes of 1048576 bytes, blocks of 1024 bytes, counting from 0
Device Boot Start End MiB #blocks Id System
/dev/sda1 * 0+ 258- 259- 265072 83 Linux
/dev/sda2 258+ 4259- 4001- 4096575 83 Linux
/dev/sda3 4259+ 8259- 4001- 4096575 83 Linux
/dev/sda4 8259+ 76316- 68057- 69689970 5 Extended
/dev/sda5 8259+ 11264- 3005- 3076447 83 Linux
/dev/sda6 11264+ 19265- 8002- 8193149+ 83 Linux
/dev/sda7 19265+ 21265- 2001- 2048287 82 Linux swap / Solaris
/dev/sda8 21265+ 76316- 55051- 56372084+ 83 Linux
Successfully wrote the new partition table
Re-reading the partition table ...
Formatting /dev/sda1 as ext3 : boot
Formatting /dev/sda2 as ext3 : root
Formatting /dev/sda3 as ext3 : home
Formatting /dev/sda5 as ext3 : log
Formatting /dev/sda6 as ext3 : dump
Creating swap /dev/sda7: swap
...Done