Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 58)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 58
Enabling /etc/fstab swaps: [ OK ]
INIT: Entering runlevel: 3
Entering non-interactive startup
Starting Software Watchdog daemon (watchdog): [ OK ]
Starting enterprise event logger: [ OK ]
Starting remote event logger: [ OK ]
Identifying Ethernet Interfaces : eth0 eth1 eth2 eth3 eth4
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
Bringing up interface eth1:
Determining IP information for eth1... failed.
[FAILED]
Bringing up interface eth2:
Determining IP information for eth2... done.
[ OK ]
Bringing up interface eth3:
Determining IP information for eth3... failed.
[FAILED]
Bringing up interface eth4:
Determining IP information for eth4... done.
[ OK ]
Starting syslog-ng: [ OK ]
Starting ipmi drivers: [ OK ]
Starting portmap: [ OK ]
Mounting other filesystems: [ OK ] Agent Daemon:
/opt/motorola/bin/hpmagentd...[ OK ]
Starting acpi daemon: [ OK ]