Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 55)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 55
ata1.00: 156301488 sectors, multi 16: LBA48 NCQ (depth 0/32)
ata1.00: configured for UDMA/133
isa bounce pool size: 16 pages
NOHZ: local_softirq_pending 10
NOHZ: local_softirq_pending 10
scsi 0:0:0:0: Direct-Access ATA ST980817SM 3.AA PQ: 0 ANSI: 5
NOHZ: local_softirq_pending 10
NOHZ: local_softirq_pending 10
sd 0:0:0:0: [sda] 156301488 512-byte hardware sectors (80026 MB)
NOHZ: local_softirq_pending 10
sd 0:0:0:0: [sda] Write Protect is off
NOHZ: local_softirq_pending 10
NOHZ: local_softirq_pending 10
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support
DPO or FUA
NOHZ: local_softirq_pending 10
NOHZ: local_softirq_pending 10
sd 0:0:0:0: [sda] 156301488 512-byte hardware sectors (80026 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support
DPO or FUA
sda: sda1 sda2 sda3 sda4 < sda5 sda6 sda7 sda8 >
sd 0:0:0:0: [sda] Attached SCSI disk
ehci_hcd 0000:00:1d.7: PCI INT A -> GSI 23 (level, low) -> IRQ 23
ehci_hcd 0000:00:1d.7: EHCI Host Controller
ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:1d.7: debug port 1