Artesyn PrAMC-7211 PNE3.0 Software Installation Guide (June 2014) - Manual (Page 35)

PrAMC-7211 Software Installation
PrAMC-7211-PNE3.0 Software Installation Guide (6806800L07B) 35
2.3.3 USB Based Installation
For installing BBS software on PrAMC-7211 blade in 4440 chassis, perform the following:
1. Setup DHCP configuration, see Setting Up DHCP Configuration on page 36 .
2. Modify the contents of PrAMC721x-WR-3.0-BBS-RM01-
1.0.2/usb/pxelinux.cfg/default
file
From
TIMEOUT 50
DEFAULT kernel initrd=minrootfs.cpio.gz rdinit=/linuxrc
console=ttyS0,9600n8 INTF=front
TFTPSERVER=192.168.2.20:/PrAMC721x-WR-3.0-BBS-RM01-PrePINV
DHTMOUT=6 TIMEOUT=16
To
TIMEOUT 50
DEFAULT kernel initrd=minrootfs.cpio.gz rdinit=/linuxrc
console=ttyS0,9600n8 INTF=front
TFTPSERVER=192.168.2.20:/PrAMC721x-WR-3.0-BBS-RM01-1.0.2/usb
DHTMOUT=6 TIMEOUT=16
Modify the TFTP server IP address also according to the installation setup.
3. Change BIOS setting boot option to netboot on PrAMC-7211, see Changing BIOS Setting on
page 36 .
After BIOS settings are changed and saved, the blade reboots and image is picked up
automatically and starts installation.
4. Change BIOS setting boot option to USB boot on PrAMC-7211, see Changing BIOS Setting
Boot Option to USB Boot on page 36 .