Artesyn RTM-ATCA-736x-DD Installation and Use (June 2014) - Manual (Page 18)

Introduction
RTM-ATCA-736X-DD Installation and Use (6806800L82C) 18
Hard Disk Status #1 and #2 None Off SAS Drive Carrier not installed
Green Off Disk in service
Green Blink Disk I/O on SAS port A
Amber Blink Preparing for removal
Amber On Ready/Safe for removal
Hot Swap (HS) Blue On Management power available to the
module and the module can safely
be extracted
Off The module is operational and is
unsafe for extraction
Long Blink Delay before module is activated
Short Blink Delay before module is de-activated
Fault or “Out of Service”
(OOS) Amber/Red On Module fault set by shelf manager or
12V payload power not detected.
Off No module fault 12V payload power
is being supplied to board
In Service (IS) Green On 12V payload power is being supplied
to board
Off 12V payload power is not detected
Amber/ Red Off This LED is multicolored
(red/green/yellow) and is program-
mable by IPMC.
Attention (ATN) Amber On/Off This LED is controlled by higher layer
software, such as middle ware or
applications.
Table 1-2 LEDs On RTM Faceplate (continued)
LED RTM Faceplate