Artesyn RTM-ATCA-736x-DD Installation and Use (June 2014) - Manual (Page 33)

Installation
RTM-ATCA-736X-DD Installation and Use (6806800L82C) 33
To install a DCA, follow these steps:
1. Verify that you have taken the necessary antistatic precautions.
2. Place the hard disk insulator on the top of the SAS-PCB assembly.
3. Align the insulator holes with the holes on the board.
4. Place the hard disk on the top of the insulator, such that it is aligned with the board SATA
connector.
5. Slide the hard disk into the SATA connector.
6. Flip assembly on its back and align the SAS-PCB holes with the insulator and hard
disk holes.
7. Attach the drive support bracket to the side of the hard disk.
8. Tighten the four flat head screws to secure the drive support bracket to the hard
disk.
9. Tighten the two pen head screws to fix the hard disk, insulator, and SAS-PCB
together.
10.Assemble the front panel bezel to the disk drive assembly using two flat head
screws.
2.11 SAS Drive Carrier Assembly Removal (Eject)
The RTM-ATCA-736X-DD can accommodate two SAS Drive Carrier Assemblies (DCA). These
assemblies support disk serviceability and hot swap without removing the RTM. This section
describes the recommended procedure for removing the hard disk assembly.