Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 55)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
55
Dottestarea from
9864
¯
Only if SYSTEM PARAMETER > Autom. dot check = Continuous.
Limits the area on the printhead where dots are tested. The parameter sets
the lower border of the dot check area. The value equals the distance to the
left printhead end in mm as viewed from above (see Fig. 13).
x mm
Setting range: refer to Tab. 3; Unit interval: 1; default setting: 0 mm
[16] Dot check area (=Dottestarea) of the printer.
Dottestarea to
9864
¯
Only if SYSTEM PARAMETER > Autom. dot check = Continuous.
Upper border of the dot check area. The value sets the distance in mm to the
left printhead end, as viewed from above.
x mm Setting range: refer to Tab. 3; Unit interval: 1; Default setting: 0 mm
0 m m 1 2 8 m m
v o n
fro m
b is
to
p rin th e a d
D o tte s tb e re ic h
D o tte s ta re a
D is p la y 2 x1 6
c h a ra c te rs