Dot Hill Systems II 200 FC - Manual (Page 109)

7-1
CH A P T E R 7
Maintaining Your Array
This chapter covers the following maintenance and troubleshooting topics:
■
“Using Software to Monitor and Manage the Array” on page 7-1
■
“Out-of-Band Connections” on page 7-2
■
“In-Band Connections” on page 7-2
■
“Other Supported Software” on page 7-2
■
“Enabling VERITAS DMP” on page 7-3
■
“The VERITAS Volume Manager ASL” on page 7-4
■
“Battery Operation” on page 7-4
■
“Viewing Event Logs on the Screen” on page 7-5
■
“Upgrading Firmware” on page 7-7
■
“Installing Firmware Upgrades” on page 7-7
■
“Controller Firmware Upgrade Features” on page 7-7
■
“Upgrading SES and PLD Firmware” on page 7-8
■
“Replacing the Front Bezel and Ear Caps” on page 7-8
7.1 Using Software to Monitor and Manage the
Array
This section describes the software management tools available for monitoring and
managing the FC, SATA, or SATA SE array with in-band connections.
Note –
The SANscape CLI and the SANscape software can also be accessed through
the Ethernet port for out-of-band management of the array. See “Setting Up Out-of-
Band Management Over Ethernet” on page 4-28.
The following software management tools are provided with your array. The
documentation CD provides the related user guides.
■
SANscape provides centralized storage configuration, maintenance, and monitoring
functions. Refer to the SANscape User’s Guide for in-band setup procedures.