Dot Hill Systems II 200 FC - Manual (Page 51)

Chapter 4 Connecting Your Array 4-3
4. Lift the pawl off the threaded part of the lock body, as shown in the second panel of
Figure 4-2.
Figure 4-2 Sequence of Steps to Change Front Bezel Locks So Keys Cannot Be Removed
5. Set the pawl aside, face up, so that you can remember its orientation when you replace
it.
6. Use the key to turn the lock 180 degrees, as shown in the third panel of Figure 4-2.
7. Replace the pawl in the same orientation as before, as shown in the fourth panel of
Figure 4-2.
8. Hold the key in place and use the nut driver to refasten the locking nut that holds the
pawl in place, as shown in the fifth panel of Figure 4-2. Be careful not to cross-thread
the nut.
Caution – Be sure to hold the key in place. Otherwise there is a risk of breaking the
small tab on the lock that serves as a stop.