Dot Hill Systems II 200 FC - Manual (Page 197)

Appendix I Configuring an HP Server Running the HP-UX Operating System I-3
FIGURE I-1 RAID Array COM Port Connected Locally to the Serial Port of a Host System
2. Power on the array.
3. After the array is powered up, power on the HP server and log in as
root
, or become
superuser
if you are logged in as a user.
4. Start the Kermit program and set the parameters as shown.
Use the device-specific name for the serial port you are using. In the example, the
serial port being configured is
/dev/tty0p1
.
Note – To return to the Kermit prompt, type Ctrl \ and then C. To exit Kermit, first
return to the Kermit prompt and then type
exit
.
# kermit
Executing /usr/share/lib/kermit/ckermit.ini for UNIX...
Good Morning!
C-Kermit 7.0.197, 8 Feb 2000, for HP-UX 11.00
Copyright (C) 1985, 2000,
Trustees of Columbia University in the City of New York.
Type ? or HELP for help.
(/) C-Kermit>set line /dev/tty0p1
(/) C-Kermit>set baud 38400
/dev/tty0p1, 38400 bps
(/) C-Kermit>set term byte 8
(/) C-Kermit>set carrier-watch off
(/) C-Kermit>C
Connecting to /dev/tty0p1, speed 38400.
The escape character is Ctrl-\ (ASCII 28, FS)
Type the escape character followed by C to get back,
or followed by ? to see other options.
COM port
COM port