Beurer BM 85 - Manual (Page 31)

31
8. Transferring measurements
Transfers using the USB interface
Connect the blood pressure monitor to your PC using the USB
cable.
No data transfer may be launched whilst performing a
measurement.
PC is shown on the display.
Begin the data transfer in the “HealthManager” PC
software. During the data transfer, an animation is
shown on the display. A successful data transfer is
displayed as in figure 1. If the data transfer is
unsuccessful, an error message appears as in
figure 2. In this case, interrupt the PC connection
and start the data transfer again.
After 30 seconds of not being in use or if communi-
cation with the PC is interrupted, the blood pressu-
re monitor switches itself off automatically.
Bluetooth
® Smart transfers
It is also possible to transfer the measured values saved on the
device to your smartphone using Bluetooth ® Smart.
You will need the Beurer „HealthManager“ app for this. The
app is available from the App Store.
Proceed as follows to transfer values:
data is transferred if Bluetooth ® has been activated in the set-
tings menu. The symbol appears in the top left of the display
(see section 4 “Preparing for the measurement”).
Step 1: BM 85
activate Bluetooth
® on your device (see section
4 “Preparing for the measurement, Blue-
tooth ® ”).
Step 2: Beurer “HealthManager” app
In the Beurer “HealthManager” app, add the
BM 85 under “Settings/My devices”.
Step 3: BM 85
take a measurement.
Step 4: BM 85
data transfer immediately
following measurements.
• Select the desired user
memory. Start Bluetooth ®
data transfer (chapter 5)
Step 4: BM 85
Data transfer at a later point:
• go to memory mode
(chapter 7). Select the
desired user memory.
Bluetooth ® data transfer
starts automatically.
The Beurer “HealthManager” app must be active to allow
data transfers.
fig. 1
fig. 2