Beurer GL 50 (mg/dL) - Manual (Page 17)

Beurer GL50 mg/dL 17
2 Prepare all parts
Prepare the following items: GL50 monitor (A), test strip box (D) and sterile lancet needles (E).
You will also need the AST cap for measurements on other parts of the body (B).
3 Wash your hands
Wash your hands with soap and warm water before taking a blood sample. This not only en-
sures optimal hygiene but also encourages good blood circulation at the puncture area on the
finger. Dry your hands carefully. Also ensure that the puncture area is hygienically clean when
taking blood samples from other body parts (AST).
Warning
If you have used alcohol for cleaning, ensure that the area has fully dried prior to measuring.
5.2 Preparing the lancing device for taking a sample
1 Remove cap
First bend the clip backwards.
Hold the monitor by the lancing device cover in one hand. With your
other hand, remove the cap from the lancing device.
2 Insert lancet needle
Insert a sterile lancet needle into the lancing device.
Push firmly on the lancet until it audibly engages and it cannot be
pushed further into the holder.