Beurer GL 50 (mg/dL) - Manual (Page 28)

28 Beurer GL50 mg/dL
6 m
easurement memory
For each measurement, your blood glucose value is automatically saved with the date and time un-
less “ ” was activated for a blood glucose measurement using control solution.
The memory can store a maximum of 480 measured values. If the memory is full, the oldest value is
replaced by the most recent value. You can call up every individual measured blood glucose value.
You can also calculate and display the average value for the last 7, 14, 30 and 90 days.
Note
• If you have already saved measured values and you reset the date, the average values are calculated
as from the new period.
• “---” indicates an empty memory for measured values. Press the ON/OFF button to switch off the
device.
6.1 Displaying individual values
The individual values from the last 480 measurements are displayed. The most recent measured
value is displayed first, and the oldest last. The date and time are also displayed on the monitor at
the same time.
1 Switch the monitor on using the on/off button [1]. The initial display is shown briefly. Press
the “+” or “–” rocker switch [3].
2 “Mem” and the number of saved blood glucose tests are displayed briefly (Image 1). The
display then changes to the most recent saved value including the measurement unit, date,
time, “Mem” and any label (Image 2).
Image 1 Image 2
3 Each time you press the rocker switch “–” again, first the memory space number will be
displayed and then the relevant measured value. You can display a maximum of 480 pre-
vious measurements.
4 You can cancel the process at any time. To do so, press the ON/OFF button or wait until
the device switches itself off automatically after two minutes.