Bronkhorst CEM W-300B - Manual (Page 14)

BRONKHORST HIGH-TECH B.V.
4 Readout and Control unit
The use of standard readout unit, manufactured by Bronkhorst HIGH-TECH B.V. is recommended.
4.1 Application with BHT standard Readout and Control unit
4.1.1 General
The BHT Readout and Control unit with temperature control unit offers the ability to power the CEM and to
set the desired temperature for the heater system of the CEM. The temperature inside the CEM is monitored
with a PT-100 temperature sensor, the signal of which is being used by the temperature controller to control
the adjusted temperature.
4.1.2 Rearpanel connector
connector (1) 6-pin female
Pinnumber Description
A
B
C
D
E
F
Not connected
Not connected
PT100 (T-sensor)
PT100 (T-sensor)
Safety switch
Safety switch
connector (2) 5-pin female
Pinnumber Description
110…120Vac supply
Description
220…240Vac supply
A
B
C
D
E
PE
Heater (N)
Heater (L)
Heater (L)
Heater (N)
PE
Not connected
Heater (N)
Heater (L)
Not connected
For other signals consult manual 9.17.076
4.1.3 Operation
For operation of the E-8000 based R/C panel consult manual 9.17.076.
page 14 9.17.082